LB 100-240 Electric Steam Generators

LB-120 (H) 120 Kilowatt (kW) Electrical Power Rating High Pressure Electric Steam Generator

Dimensions

Length	51 in
Width (No Options)	30 in
Width (with MAFD option)	34 in
Height	37 in

Minimum Clearance

Total Height	45 in
Total Length	120 in
Total Width	60 in

Downloads

Industry Standards

American Society of Mechanical Engineers (ASME) - Boiler and Pressure Vessel Code
American Society of Mechanical Engineers (ASME) - CSD-1
Canadian Underwriters Laboratories (cUL)
Underwriters Laboratories (UL)

Standard Features

ASME Certified	High Pressure Safety Reset
UL Listed and labeled under UL 834	Dual Pressure Controls (UL 353)
Low Level Cut-Off (LLCO) (UL 353)	Safety Relief Valve possessing the ASME V Mark

Recommended Options (Non-Standard)

Spare Parts Package	Motorized Automatic Flush and Drain (MAFD)
Single Service Transformer	5-Micron Water Filter

Specifications

Brands	Electro-Steam™
Variant	High Pressure
Electrical Power	120 kW
Power Supply Voltage¹	208 VAC, 230 VAC, 380 VAC, 415 VAC, 440 VAC, 480 VAC, 600 VAC
Phase	3
Frequency	50 Hz, 60 Hz
Boiler Horse Power	12 bhp
Steam Capacity²	414 lb/hr (187.79 kg/hr)
Water Consumption	49.61 gal/hr (187.79 L/hr)
Gross British Thermal Units (BTU) Output	401704 Btu/hr
Maximum Boiler Pressure	100 psi
Operating Pressure	0 to 80 psi
Maximum Boiler Capacity	26.5 gal
Note for Operating Pressure	Factory Set at 80 psi
Boiler Fill Capacity	22.0 gal
Boiler Material³	Carbon Steel
Cabinet Material	304 Stainless Steel
Plumbing Material	Brass (Schedule 40), Carbon Steel (Schedule 40)

Amperage by Voltage (3Ø Phase)

208 VAC	240 VAC	380 VAC	415 VAC	440 VAC	480 VAC	600 VAC
333.1 A (166.5 A per Box)	314.3 A (157.2 A per Box)	182.3 A (91.2 A per Box)	166.9 A (83.5 A per Box)	157.5 A (78.7 A per Box)	144.3 A (72.2 A per Box)	115.5 A (57.7 A per Box)

Plumbing Connection Sizes

Water Inlet	1/2" NPT (National Pipe Thread) (Female) - Y-Strainer, Brass
Steam Outlet	3/4" NPT (National Pipe Thread) Union - Ball Valve, Brass
Safety Valve	1-1/4" NPT (National Pipe Thread) (Female) - Safety Valve, Brass
Drain	1" National Pipe Thread (NPT) (Female) - Ball Valve, Brass
Additional Drain (Motorized Automatic Flush and Drain (MAFD) Option Included)	1" NPT (National Pipe Thread) (Female) - Motorized Valve, Brass

Options

Spare Parts Package Includes	18-Month Warranty (12-Month Standard) (2) Electric Heaters and (2) Heater Gaskets (2) Sight Glass Tubes and (4) Washers (1) Pressure Control (1) Contactor
Motorized Automatic Flush and Drain (MAFD)	During Start-Up before steam pressure is accumulated, the Motorized Automatic Flush and Drain option cycles fresh water through the boiler for 0-300 seconds (Factory set for 180 seconds or three (3) minutes). As old water is drained out, fresh water will be cycled in. This drain valve will not open if boiler pressure exceeds 5 psi, and the electric heaters are locked out during flush cycle.
Single Service Transformer	Supplied standard with all portable steam generators, the Single Service Transformer steps down the primary high voltage to provide 120 VAC Single Phase (1Ø) to the controls; with this option, only the one (1) primary high voltage supply is required.
5-Micron Water Filter	2-stage, 5-micron water filter installed into incoming water line to reduce sediment, dirt, rust, chlorine, andeven odor from incoming water supply.
Manual Low Water Reset⁴	Manual Low Water Reset trips if the electric heaters shut-off because of a low water condition. Reset must be manually pressed to resume steam production.
Portable Mounting Includes	Wheels Push Handle Single Service Transformer Option
Water Feed Booster Pump	Supplied standard on any steam generator with an operating pressure higher than 15 psi. The Water FeedBooster Pump increases your incoming water pressure to overcome the operating pressure of the steam generator. The Pump requires a 5-150 psi water supply with a minimum flow rate of 2 gpm.

¹ Electro-Steam™ 100-240 kW electric steam generators require three (3) power supplies: Two (2) primary high voltage supplies and one (1) secondary 120 VAC 1Ø, 50/60 Hz supply. Each generator is custom built to accommodate two (2) supplies of only one (1) customer specific high voltage for the heaters. 120 VAC 1Ø, 50/60 Hz must also be supplied for the controls, unless the Single Service Transformer option is added.
² Calculations are based off of a 212 °F boiler feed-water temperature. Boiler feed-water temperatures that range between 60 °F and 140 °F, are approximately 80% to 90% of the calculated values shown. Boiler feed-water must not exceed 140 °F.
³ Wetted Surfaces.
⁴ A Manual Low Water Reset Button is supplied standard with every steam generator, but it is disabled. If this Reset Button is required as per your local boiler codes, simply plug the two attached wires into the PC-Board terminals labeled "Reset".

Free Resource

Conveyor Belt Cleaning Solutions eBook cover

Conveyor Belt Cleaning Solutions for the Food & Beverage Industry

Learn how all-electric dry steam sanitation is transforming hygiene standards across food processing and beverage operations. Download our free industry guide.

Download Free eBook

Get in Touch

Ready to Find the Right Steam Solution?

Our engineering team is here to help you select the right generator for your application. Custom specifications, expert guidance, same-day part shipping.

Request a Quote Request a Demonstration