S.S. LB 100-240 Electric Steam Generators

S.S. LB-120 (L) 120 Kilowatt (kW) Electrical Power Rating Low Pressure Electric Steam Generator

Dimensions

Length	51 in
Width	30 in
Height	37 in

Minimum Clearance

Total Length	120 in
Total Width	60 in
Total Height	45 in

Downloads

Industry Standards

American Society of Mechanical Engineers (ASME) - Boiler and Pressure Vessel Code
American Society of Mechanical Engineers (ASME) - CSD-1
Canadian Underwriters Laboratories (cUL)
Underwriters Laboratories (UL)

Standard Features

316L Stainless Steel on all Wetted Surfaces	ASME Certified
High Pressure Safety Reset	UL Listed and labeled under UL 834
Dual Pressure Controls (UL 353)	Low Level Cut-Off (LLCO)
Safety Relief Valve possessing the ASME V Mark

Recommended Options (Non-Standard)

Spare Parts Package

Single Service Transformer

Specifications

Brands	Electro-Steam™
Variant	Low Pressure
Electrical Power	120 kW
Power Supply Voltage¹	208 VAC, 230 VAC, 380 VAC, 415 VAC, 440 VAC, 480 VAC, 600 VAC
Phase²	3
Frequency	50 Hz, 60 Hz
Boiler Horse Power	12 bhp
Steam Capacity³	414 lb/hr (187.79 kg/hr)
Water Consumption	49.61 gal/hr (187.79 L/hr)
Gross British Thermal Units (BTU) Output	401704 Btu/hr
Maximum Boiler Pressure	15 psi
Operating Pressure	0 to 11 psi
Note for Operating Pressure	Factory Set at 11 psi
Maximum Boiler Capacity	26.5 gal
Boiler Fill Capacity	22.0 gal
Boiler Material⁴	316L Stainless Steel
Cabinet Material	304 Stainless Steel
Plumbing Material	316L Stainless Steel (Schedule 40)

Amperage by Voltage (3Ø Phase)

208 VAC	240 VAC	380 VAC	415 VAC	440 VAC	480 VAC	600 VAC
333.1 A (166.5 A per Box)	314.3 A (157.2 A per Box)	182.3 A (91.2 A per Box)	166.9 A (83.5 A per Box)	157.5 A (78.7 A per Box)	144.3 A (72.2 A per Box)	115.5 A (57.7 A per Box)

Plumbing Connection Sizes

Water Inlet	1/2" National Pipe Thread (NPT) (Female) - Street Elbow, 316L Stainless Steel (SS)
Steam Outlet	1" National Pipe Thread (NPT) (Female) - Ball Valve, 316L Stainless Steel (SS)
Safety Valve	2" National Pipe Thread (NPT) (Female) - Safety Valve, 316L Stainless Steel (SS) Trim (Wetted Surfaces), Brass Body
Drain	1" National Pipe Thread (NPT) (Female) - Ball Valve, 316L Stainless Steel (SS)

Options

Spare Parts Package Includes	18-Month Warranty (12-Month Standard) (2) Electric Heaters and (2) Heater Gaskets (2) Sight Glass Tubes and (4) Washers (1) Pressure Control (1) Contactor
Single Service Transformer	Supplied standard with all portable steam generators, the Single Service Transformer steps down the primary high voltage to provide 120 VAC Single Phase (1Ø) to the controls; with this option, only the one (1) primary high voltage supply is required.
Manual Low Water Reset⁵	Manual Low Water Reset trips if the electric heaters shut-off because of a low water condition. Reset must be manually pressed to resume steam production.
Portable Mounting Includes	Wheels Push Handle Single Service Transformer Option
Water Feed Booster Pump	The minimum requirement for your water pressure is the operating pressure +25 psi; if your water pressure is below this requirement, this option must be added. The Water Feed Booster Pump increases your incoming water pressure to overcome the operating pressure of the steam generator. The Pump requires a 5-150 psi water supply with a minimum flow rate of 2 gpm.

¹ Electro-Steam™ 100-240 kW electric steam generators require three (3) power supplies: Two (2) primary high voltage supplies and one (1) secondary 120 VAC 1Ø, 50/60 Hz supply. Each generator is custom built to accommodate two (2) supplies of only one (1) customer specific high voltage for the heaters. 120 VAC 1Ø, 50/60 Hz must also be supplied for the controls, unless the Single Service Transformer option is added.
² Three Phase (3Ø) primary high voltage is standard, but steam generators with a power rating of 30 kW or lower are also available in Single Phase (1Ø) upon request.
³ Calculations are based off of a 212 ºF boiler feed-water temperature. Boiler feed-water temperatures that range between 60 ºF and 140 ºF, are approximately 80% to 90% of the calculated values shown. Boiler feed-water must not exceed 140 ºF.
⁴ Wetted Surfaces.
⁵ A Manual Low Water Reset Button is supplied standard with every steam generator, but it is disabled. If this Reset Button is required as per your local boiler codes, simply remove the jumper wire from the back of the Reset Button.

Free Resource

Conveyor Belt Cleaning Solutions eBook cover

Conveyor Belt Cleaning Solutions for the Food & Beverage Industry

Learn how all-electric dry steam sanitation is transforming hygiene standards across food processing and beverage operations. Download our free industry guide.

Download Free eBook

Get in Touch

Ready to Find the Right Steam Solution?

Our engineering team is here to help you select the right generator for your application. Custom specifications, expert guidance, same-day part shipping.

Request a Quote Request a Demonstration